49
MAINTENANCE
Cleaning of evaporating tray
The evaporating tray is located at lower side on the front. Clean the evaporating tray twice or three
times per year with water. Before removing the evaporating tray, wipe off the water in it. The
procedure to remove is as follows:
1. Remove 2 black screws fixing the evaporating tray at the bottom of the front frame.
2. Pull out the evaporating tray 3 cm toward you horizontally to avoid the spillage of the water. Take
care not to damage the evaporating pipe.
3. Slide out the evaporating tray on the floor after touching to the floor.
4. To replace the evaporating tray, follow the procedure in reverse.
Note: Consult Sanyo sales representative or agent when cleaning the evaporating tray.
Replacement of lamp
Turn off the power switch and disconnect the power supply plug from the outlet.
1. Remove 2 screws fixing the shade by using a screw driver as shown in the figure.
2. Pull the lamp downward with lead wire connected.
3. Install a new lamp in the cover and adjust the lamp direction according to the socket terminal.
4. Replace the shade and fix it with 2 screws.
• The lamp is consumable. (type:FL-15D)
Note: Consult Sanyo sales representative or agent when replacing the lamp.
Blackscrews
To Next Page
Loading...
