Sanyo MPR-721 User Manual

INSTALLATION
1. Removing the packaging materials and tapes
Remove all transportation packaging materials and
tapes. Open the doors and ventilate the unit. If the
outside panels are dirty, clean them with a diluted
neutral dishwashing detergent. (Undiluted detergent
can damage the plastic components. For the dilution,
refer to the instruction of the detergent.) After the
cleaning with the diluted detergent, always wipe it off
with a wet cloth. Then wipe off the panels with a dry
cloth.
2. Adjusting the leveling feet
Extend the leveling feet by rotating them
counterclockwise to contact them to the floor.
Ensure the unit is level. See Fig. 1.
3. Fixing the unit
Two fixtures are attached to the rear of the frame.
Fix the frame to the wall by attaching a rope or chain
between the wall and the fixtures.
If holes can be drilled in the wall, drill a 10.5 mm
diameter hole (Fig. 2) and fix the unit by using the
special bolt-nut supplied. This bolt-nut can only be
used on a concrete wall.
4. G round (earth)
The ground (earth) is for preventing the electric shock in the case of the electrical insulation is somehow
d egraded. Always ground the unit at the time of installation. _
^WARNING
Use a power supply outlet with ground (earth) to prevent electric shock. If the power supply outlet is
not grounded, it is necessary to install a ground by qualified engineers.
Never ground the unit through a gas pipe, water main, telephone line or lightning rod. Such
grounding may cause electric shock in the case of an incomplete circuit.
13
51 -

Sanyo MPR-721 Specifications

General

Brand	Sanyo
Model	MPR-721
Category	Refrigerator
Language	English