Sanyo MPR-721 - OPTIONAL COMPONENTS; Attachment of recorder MTR-G04 A or MTR-G04 C

OPTIONAL COMPONENTS
Attachment of recorder MTR-G04A or MTR-G04C
1. Follow the instruction manual provided with the
temperature recorder and attach the recorder to the
fixture MPR-S7.
2 . Open the aperture for the recorder on the front top
of the unit by removing the locating screw and remove
the cover by pushing the shaft on both sides outwards.
(Fig. 6)
3. Remove the black rubber caps (inside and outside)
on the access port located at the top corner of the unit
and take the insulation out of the access port.
4 . Pass the recorder sensor into the chamber through
the access port. (Fig. 7)
5. Fix the recorder sensor to the fan cover located at
the top of the chamber with the binder provided. (Fig.
8 )
6. Route the capillary on the top of the chamber and
fix it at two points with the provided clips and screws.
(Fig. 9)
7. Replace the insulation in the access port.
8. Make a cut on the rubber caps so that the capillary
can pass the caps and place them back on the access
port (inside and outside). (Fig. 10)
9 . Bind the lead wire on the right upper side of the unit
with the provided band.
10. Remove the connector cap located on the left side
and then connect the recorder connector.
11. Attach the recorder on the front cover with a
screw.
- 70 -
32