Sanyo PDG-DXL2000 - Side Terminal

11
< 3D SYNC OUT
Connect a 3D sync. signal cable for an IR wireless
emitter to this jack (p.48)
B LAN Connection Terminal
Connect the LAN cable (refer to the owner’s
manual of "Network Set-up and Operation").
 COMPUTER IN 1/COMPONENT IN
Connect output signal from a computer, RGB scart
21-pin video output or component video output to
this terminal (pp.16, 18).
 COMPUTER IN 2/MONITOR OUT
This terminal is switchable and can be used
for input from a computer or output to the other
monitor.
Set the terminal up as either Computer input or
Monitor output properly. [Used for Monitor out,
this terminal outputs only incoming signal from
COMPUTER IN 1/COMPONENT IN terminal (pp.
16, 56)].
 HDMI
Connect the HDMI signal from computer or video
equipment to this terminal (pp.16, 18).
D S-VIDEO IN
Connect the S-VIDEO output signal from video
equipment to this jack (p.17).
J VIDEO IN
Connect the composite video output signal to this
jack (p.17).
8 AUDIO IN
Connect the audio output signal from video
equipment connected to D or J to this jack. For
a monaural audio signal (a single audio jack),
connect it to the L (MONO) jack (p.17).
E COMPUTER 1/COMPONENT AUDIO IN
Connect the audio output (stereo) from a computer
or video equipment connected to  or  to this
jack (pp.16, 18).
G COMPUTER 2 AUDIO IN
Connect the audio output (stereo) from a computer
connected to  to this jack (pp.16, 18).
L AUDIO OUT (VARIABLE)
Connect an external audio amplifier to this jack
(pp.16-18).
This terminal outputs sound from AUDIO IN
terminal (8, E or G) or HDMI terminal  (digital
audio).
H CONTROL PORT
When controlling the projector with RS-232C,
connect the control equipment to this connector
with the serial control cable.
Part Names and Functions
D
Side Terminal
J 8 E LG H <
B   