Sanyo PDG-DXL2000 - Input Source Selection (Component, Scart, HDMI)

42
Choose Computer 1(Component) or Computer 1(Scart)
by pressing the the COMPONENT or COMPUTER 1 button
on the remote control; choose HDMI by pressing the HDMI
button on the remote control.
Before using these buttons, correct input source should be
selected through Menu operation as described below.
1
Input Menu
2
Use the Point 54 buttons to select Computer 1 and
then press the Point  button; use the Point 54
buttons to select Component or RGB(Scart) and then
press the SELECT button.
Input Source Selection (Component, Scart, HDMI)
When the input source is coming from video
equipment connected to the COMPUTER
IN 1/COMPONENT IN terminal with a
Component-VGA Cable, select Component.
Component
When the input source is coming from video
equipment connected to the COMPUTER
IN 1/COMPONENT IN terminal with a Scart-
VGA Cable, select RGB (Scart).
RGB (Scart)
Press the MENU button to display the On-Screen
Menu. Use the Point 54 buttons to select Input and
then press the Point  or the SELECT button.
Note:
When the Input Search function is set to On 1 or On 2 in
the Auto setup function, the input signal will be searched
automatically (p.51).
COMPUTER 1 button
Remote Control
Use the Point 54 buttons to select HDMI, and then
press the SELECT button;
Computer 1 (RGB)
Computer 1 (Scart)
COMPONENT button
Computer 1
(Component)
Video Input
HDMI button
HDMI
When the video signal is connected to the
HDMI terminal, select HDMI.
HDMI
Direct Operation
Menu Operation
OR