24
Menu Bar
For detailed functions of each menu, see “Menu Tree” on pages 72-73.
①
②
③
④
⑤
⑥
⑦
⑧
Main Menu
Sub-Menu
⑨
⑩
①
Input Used to select an input source from Computer 1, Computer 2, HDMI, Video or
S-video. (pp.30-31, 41-42)
②
PC adjust Select Auto PC adj., Fine sync, Total dots, Horizontal, Vertical, Current mode and
Clamp to adjust the parameters to match with the PC input signal format. (pp.33-35)
③
Image select Used to select an image mode from among Dynamic, Standard, Real, Cinema and
Image 1-4. (p.36)
④
Image adjust
For computer source, used to adjust computer image [Contrast, Brightness, Color
temp., White balance (Red/Green/Blue), Sharpness and Gamma]. (p.37)
For video or HDMI source, used to adjust picture image [Contrast, Brightness, Color,
Tint, Color temp., White balance (Red/Green/Blue), Sharpness, Gamma, Noise
reduction and Progressive]. (pp.44-45)
⑤
Screen
For computer source, used to adjust size of the image [Normal, Full, Wide (16:9), Zoom,
True, Custom, Digital zoom +/–, Keystone, Ceiling and Colorboard]. (pp.38-40)
For video or HDMI source, used to set size of image [Normal, Full, Wide (16:9), Zoom,
Custom
, Keystone, Ceiling and Colorboard
]. (pp.46-47)
⑥
Sound Used to adjust the volume or mute the sound. (p.27)
⑦
Setting
Used to set the projector’s operating configurations. (pp.50-62)
⑧
Information Display the input source information: Input, H-sync freq., V-sync freq., Screen,
Language, Lamp status, Lamp counter, Power management, Key lock, PIN code
lock, Remote control, and SERIAL NO.. (p.63)
⑨
Network See owner’s manual of “Network Set-up and Operation”.
⑩
Guide The key operation is displayed.
Basic Operation
To Next Page
Loading...
