Sanyo PDG-DXL2000 - Connecting to Component Video Equipment

18
Installation
Connecting to Component Video Equipment
Cables used for connection
• Audio cables
• Scart-VGA cable
• Component cable
• Component-VGA cable
• HDMI cable
(Cables are not supplied with this projector.)
External Audio Equipment
COMPUTER 1/
COMPONENT
AUDIO IN
Audio cable
(stereo)
Audio Input
Component Video
Output
(Y, Pb/Cb, Pr/Cr)
RGB Scart
21-pin Output
Audio Output
Scart-VGA
cable
Component-
VGA cable
Component
cable
COMPUTER IN 1/
COMPONENT IN
HDMI
HDMI Output
HDMI
cable
Audio cable
(stereo)
COMPUTER IN 2/
MONITOR OUT
AUDIO OUT
(stereo)
Refer to
the Monitor
Output Sig-
nal Table.
Input Terminal Monitor Out Cable
COMPUTER 1/
COMPONENT
D-sub15
RGB (PC analog) YES
Y, Pb/Cb, Pr/Cr YES
=
RGB (SCART) NO
COMPUTER 2
D-sub15
RGB NO
HDMI
HDMI
HDMI NO
S-VIDEO
DIN-4
S-video NO
VIDEO
RCA
Video NO
Monitor Output Signal Table
= A cable with one end D-sub 15 and the other end (Black box)
compatible with each equipment is necessary.
Note:
• When the AUDIO OUT is plugged-in, the projector's built-in
speaker is not available.
• See page 78 for ordering optional cables.
Unplug the power cords of both the
projector and external equipment
from the AC outlet before connecting
cables.