30
Choose Computer 1(RGB) by pressing the COMPUTER 1
button on the remote control.
Before using these buttons, correct input source should be
selected through Menu operation as described below.
1
Input Menu
2
3
Input Source Selection (Computer 1: RGB)
Computer Input
COMPUTER 1 button
Note:
When the Input Search function is set to On 1 or On 2 in
the Auto setup function, the input signal will be searched
automatically (p.51).
Computer
1
Remote Control
Press the MENU button to display the On-Screen
Menu. Use the Point
54 buttons to select Input and
then press the Point
or the SELECT button.
Use the Point
54 buttons to select Computer 1.
When Computer 1 is selected, press the Point
to
access the submenu items. Use the Point
54 buttons
to select the RGB input source and then press the
SELECT button.
Computer 1(RGB)
Computer 1(Scart)
Direct Operation
Menu Operation
To Next Page
Loading...
