26
Basic Operation
Auto setup function is provided to automatically execute
the setting of Auto setup (includes Input search and Auto
PC adj. functions) in the Setting Menu by just pressing the
AUTO SET button on the remote control. Refer to page 51
for the setting of the Auto setup function.
Note:
Fine sync, Total dots, Horizontal and Vertical position of
some computers can not be fully adjusted with the Auto
PC adjustment function. When the image is not provided
properly with this operation, manual adjustments are
required. (pp.34-35)
Auto Setup Function
Remote Control
AUTO SET button
Press the KEYSTONE button on the remote control or on
the top control. The Keystone dialog box appears. Use
the Point
54 buttons to correct keystone distortion. The
keystone adjustment can be stored (See pages 40, 47).
Reduce the upper width
with the Point
5 button.
Reduce the lower width
with the Point 4 button.
• The white arrows indicate that there is no correction.
• A red arrow indicates the direction of correction.
• An arrow disappears at the maximum correction.
• If you press the KEYSTONE button on the remote
control or on the top control once more while the
keystone dialog box is being displayed, the keystone
adjustment will be canceled.
• The adjustable range is limited depending on the
input signal.
Keystone Correction
Remote Control
POINT 54 buttons
KEYSTONE button
Top Control
KEYSTONE button
POINT 54 buttons
To Next Page
Loading...
