Sanyo PLC-XF47 - Page 35

- 35 -
A
A
A
A
D
D
C
C
(a)
(a)
B
B
8-3
Mains switch Unit removal.
1. Remove 4 screws-A and remove the Main-SW Unit.
2. Remove 2 screws-B and remove the Lamp Cover Switch (SW902).
3. Remove 2 screws-D and remove the AC Inlet.
4. Unhook the stoppers and remove the Mains Switch (SW901).
Push part (a) and pull the Main Switch.
5. Remove 2 screws-C and remove the Noise Filter.
Mechanical disassemblies
To remove the Fuse.
Turns the fuse holder cover with the slot screw driver.
Remove the fuse and the fuse holder cover upward.
Fuse holder
cover
Fuse
Fuse holder
Main SW unit
Holder
SW902
AC Inlet
SW901
Noise Filter
LF901
Hook