Sanyo plc-xu4001 - Page 48

48
Setting
(QWHUD/RJR3,1FRGH
Use the Point Ÿź buttons to enter a number.
Press the Point ŻŹ buttons to fix the number
and move the red frame pointer to the next
box. The number changes to ¼. If you fixed an
incorrect number, use the Point ŻŹ buttons
to move the pointer to the number you want to
correct, and then enter the correct number.
Repeat this step to complete entering a four-digit
number.
After entering the four-digit number, move the
pointer to Set. Press the SELECT button so that
you can start to operate the projector.
If you entered an incorrect Logo PIN code, Logo
3,1FRGH and the number (¼¼¼¼) will turn red
for a moment. Enter the correct Logo PIN code
all over again.
/RJR3,1FRGHFKDQJH
Logo PIN code can be changed to your desired
four-digit number. Press the SELECT button to
select /RJR3,1FRGHFKDQJH. Current logo
3,1FRGHdialog box appears, use the Point
Ÿźbuttons to enter the current code. The New
logo PIN code input dialog box appears. Set a
new Logo PIN code, confirmation box appears,
choose <HV to set the new Logo PIN code.
Be sure to note the new Logo PIN code and keep
it on hand. If you lost the number, you could no
longer change the Logo PIN code setting.
Use the Point Ÿźbuttons to switch On or 2II,
and then press the SELECT button to make a
choice.
&KDQJHWKH/RJR3,1FRGHORFNVHWWLQJ
(QWHUD/RJR3,1FRGH
After a correct Logo PIN code
is entered, the following dialog
box appears.
&KDQJHWKH/RJR3,1FRGHORFNVHWWLQJ
&KDQJHWKH/RJR3,1FRGH
&$87,21
:+(1<28+$9(&+$1*('7+(/2*23,1
&2'(:5,7('2:17+(1(:3,1&2'(,1
&2/8012)7+(/2*23,1&2'(120(02
213$*($1'.((3,76(&85(/<
6+28/'7+(/2*23,1&2'(%(/26725
)25*277(17+(/2*23,1&2'(6(77,1*
&$112/21*(5%(&+$1*('