Sanyo PLC-ZM5000 - Side Control and Indicators

①ON/STAND-BY button
Turn the projector on or off (pp.23-24).
②MENU button
Open or close the On-Screen Menu (p.25).
⑤Point ŸźŻŹ ( VOLUME – / + ) buttons
– Select an item or adjust the value in the
On-Screen Menu (p.25).
– Pan the image in Digital zoom + mode
(p.43).
 ±$GMXVWWKHYROXPHOHYHOZLWK3RLQWŻŹ
buttons) (p.28).
⑩WARNING TEMP. indicator
Blink red when the internal temperature of
the projector exceeds the operating range
(pp.72, 79-80).
④
SHUTTER button
Close and open up the built-in shutter (p.27).
⑧POWER indicator
– Light green while the projector is in stand-
by mode.
– Light green during operations.
– Blink green in the Power management
mode (p.59).
③SELECT button
– Execute the selected item (p.25).
– Expand or compress the image in the
Digital zoom mode (p.43).
⑨LAMPindicator
 Light red during operations.
⑬LAMP REPLACE indicator
Light orange when the projection lamp
reaches its end of life (pp.69, 80).
⑪WARNING FILTER indicator
– Blink slow when the filter is being scrolled
(pp.66, 79).
– Blink fast when the filter scroll is not
working properly or the filter cartridge is not
installed (pp.66, 81).
– Light orange when the clogging of the filter
is detected or the filter counter reaches
a time set in the timer setting, urging
immediate filter/ filter cartridge replacement
(pp.65, 66, 81).
①
Side Control
Indicators (on the top panel)
Part Names and Functions
⑦INPUT button
Select an input source (pp.33-35).
⑥LENS button
Enter the focus, zoom, and lens shift
adjustment mode (p.27).
②
④
⑥
③
⑤
⑦
⑨
⑧
⑩
⑪
⑫
⑬
⑫
SHUTTER
indicator
Light blue when the shutter is closed (p.79).
Side Control and Indicators
12