Sanyo PLC-ZM5000 - Information

43
ENGLISH
Information
This page is to display the basic information of the projector status. Click
Information on the main menu.
Information
Click this button to
update the information.
Items Description
Input............................................Displays selected input and source.
System.......................................Displays selected signal system.
Signal..........................................Input signal status (Yes, No)
Screen ........................................Displays screen mode.
Lamp status .............................Displays lamp status with an icon. Refer to the table as shown in the next
page.
Security .....................................Displays the security (Key lock and PIN code lock) status.
Shutter.......................................Displays the shutter status. (OFF: open, ON: close)
PJ time(h) .................................
Displays the accumulated use time of the projector.
Lamp Corres. Value(h).....Displays the use time (Corresponding value) of the lamp.
Filter time(h)..........................
Displays the accumulated use time of the filter.
Filter condition
......................Displays filter status with an icon. Refer to the table as shown in the next
page.
* When PIP mode is active, displays Input, System, and Screen to "PIP mode".
Information
Network
Items Description
MAC address Displays MAC address of the projector.
IP address Displays the IP address of the projector.