Sanyo PLC-ZM5000 - Page 39

Computer Input
3Note:
Display area (H/V) FDQQRW EH VHOHFWHG ZKHQ 480i
575i 480p 575p 720p 1035i 1080i RU 1080pLV
VHOHFWHGLQWKH3&6\VWHP0HQXS
:KHQ LQSXW FRPSXWHU VLJQDO WR WKH SURMHFWRU 3&
DGMXVWIXQFWLRQZLOOEHFRPHDYDLODEOH
Vacant
This mode has stored
parameters.
Values of Total dots,
Position H, Position V,
Display area H and
Display area V.
Press the SELECT
button to store the
data.
Press the MENU
button to close
this dialog box.
Mode free
Store
To store the adjusted data, select Store and then press the
Point ŹRUthe SELECT button. Move the highlight to one
of the Modes 1 to 10 in which you want to store, and then
press the SELECT button.
To clear the stored data, select Mode free and then press
the Point ŹRUthe SELECT button. Move the highlight
to the Mode that you want to clear and then press the
SELECT button.
To reset the adjusted data, select Reset and press the
SELECT button. A confirmation box appears and then
select Yes. All adjustments will return to their previous
figures.
Reset
Mode free
Store
Press the
SELECT button
to clear the
stored data.
39