3
3 - 5
Control of Mini ECO-i SYSTEM
2. Wireless Remote Controller
Optional Controller (Remote Controller)
Wireless Remote Controller / RCS-SH80AG.WL (for X type) / RCS-TH80AG.WL (for S Type)
/ RCS-TRP80ANG.WL (for T, LD Type) / RCS-BH80AG.WL (for AS, U, D, F, FM Type)
I How to Use the Wireless Remote Controller
A: ON/OFF operation button This button is for turning the air conditioner on and off.
B: Transmitter When you press the buttons on the wireless remote control unit, the mark
appears in the display to transmit the setting changes to the receiver in the
air conditioner.
C: MODE button Use this button to select one of the following five operating modes.
(AUTO) : Used to automatically set cooling or heating operation. Only for single
heat pump type
(HEAT) : Used for normal heating operation. Only for heat pump type
(DRY) : Used for dehumidifying without changing the room temperature.
(COOL) : Used for normal cooling operation.
(FAN) : Used to run the fan only, without heating or cooling operation.
D: Temperature setting
buttons
: Press this button to increase the temperature setting.
: Press this button to decrease the temperature setting.
E: FAN SPEED selector button
(AUTO)
(HI)
(MED)
(LO)
: The air conditioner automatically decides the fan speeds.
: High fan speed
: Medium fan speed
: Low fan spee
d
Continued
(Temperature range: 17 to 27°C)
(Temperature range: 16 to 26°C)
(Temperature range: 18 to 30°C)
(Temperature range: 18 to 30°C)
The illustration above pictures the wireless remote control unit after the cover
has been lowered and removed.
I: FLAP bu tton
Q: Slide switch
L: SET button
P: ACL button
(ALL CLEAR)
A: ON/OFF operation button
B: Transmitter
D: Temperature setting buttons
H: A/C SENSOR button
N: VENTILATION button
J: TIMER SET button
O: Remote control sensor
F: FILTER button
K: Time setting buttons
G: ADDRESS button
E: FAN SPEED selector button
M: CL button
C: MODE button
NO
TE
06-405 Mini-ECOi_TD3 11/6/06 6:18 PM Page 5
To Next Page
Loading...