3
3 - 10
Control of Mini ECO-i SYSTEM
2. Wireless Remote Controller
2-2. Accessories
2-3. Wiring the Receiver Unit
G Connect the wire from the receiver unit to the
indoor unit remote controller terminal board. (The
wire has no polarity.)
2-4. Precautions on Simultaneous Installation of
Wired Remote Controller and Wireless
Remote Controller
By installing a wired remote controller, the wireless
remote controller kit can permit dual remote control
operation at the same time.
(Up to 2 units of remote controllers – a wireless kit
and a wired unit – can be installed.)
Dual remote control operation can control 1 or multiple
air conditioners using several remote controllers.
No.No.
G Be sure to determine the correct terminal num-
bers on the indoor unit when wiring the remote
controller. The remote controller will be dam-
aged if high voltage (such as 200 VAC) is
applied.
G The wireless remote controller kit components
cannot be used for more than 1 indoor unit at a
time. (However, separate receiver units may be
used simultaneously.)
G When a wireless remote controller kit and a
wired remote controller are used simultaneous-
ly, assign either the wireless remote controller
or the wired remote controller as the sub
remote controller unit.
G Connection diagram
To Next Page
Loading...