EasyManua.ls Logo

Sanyo SPW-CR485GXH8 - I Setting the Timer

Sanyo SPW-CR485GXH8
345 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3
3 - 30
Control of Mini ECO-i SYSTEM
3. Wired Remote Controller
Using the timer Set the timer during air conditioner operation.
Time indicator of timer Each time is pressed, the time setting increases at 0.5-hour (30 minute)
intervals. The upper limit is 72.0 hours.
Each time is pressed, the time setting decreases at 0.5-hour (30 minute)
intervals. The lower limit is 0.5 hours.
Timer indicator The timer cycles through the following options each time (TIMER
SET button) is pressed.
OFF timer Use this mode to turn off the unit automatically after a preset time elapses.
OFF cycle timer Use this mode to always turn off the unit automatically after a preset time
elapses.
ON timer Use this mode to start the unit automatically after a preset time elapses.
When 2 remote control units are being used, either a main remote control
unit or a sub remote control unit can be used for timer operations.
Recommended usage Display
To stop the air conditioner after a preset time
elapses
OFF timer
To always stop the air conditioner after a preset
time elapses
OFF cycle
timer
To start the air conditioner after a preset time
elapses
ON timer
No display
OFF
ON
Set time
OFF
ONON
OFF
Set time
Set time
OFF
ON
Set time
NOTE
I Setting the Timer
06-405 Mini-ECOi_TD3 11/6/06 6:18 PM Page 30

Table of Contents

Related product manuals