Sanyo SPW-CR485GXH8 - I How to Use the Wired Remote Controller; Wired Remote Control; RCS-SH80 AG

3
3 - 26
Control of Mini ECO-i SYSTEM
3. Wired Remote Controller
Wired Remote Controller / RCS-SH80AG
I How to Use the Wired Remote Controller
This remote control unit can be used to operate up to 8 indoor units.
Once the operation settings are made, the units can be operated by
simply pressing the ON/OFF operation button.
In the SPW-AS, U, D, F and FM series, the flap position is not shown on
the display.
The SPW-DR764/964GXH56 does not have a dry function.
A: ON/OFF operation button This button is for turning the air conditioner on and off.
B: Operation lamp This lamp lights when the air conditioner is turned on.
This lamp blinks when an error occurs or a protective device is activated.
C: MODE button Use this button to select one of the following 5 operating modes.
(AUTO) : Used to automatically set cooling or heating operation. Only for single
heat pump type.
emperature range: 17 to 27°C)
(HEAT) : Used for normal heating operation. Only for heat pump type.
emperature range: 16 to 30°C)
(DRY) : Used for dehumidifying without changing the room temperature.
emperature range: 18 to 30°C)
(COOL) : Used for normal cooling operation.
emperature range: 18 to 30°C)
(FAN) : Used to run the fan only, without heating or cooling operation.
D: Temperature setting
buttons
: Press this button to increase the temperature setting.
: Press this button to decrease the temperature setting.
E: FAN SPEED selector button
(AUTO)
(HI)
(MED)
(LO)
: The air conditioner automatically decides the fan speeds.
: High fan speed
: Medium fan speed
: Low fan spee
d
I: FLAP button
H: UNIT button
L: SET button
B: Operation lamp
D: Temperature setting
buttons
C: MODE button
N: VENTILATION button
J: TIMER SET button
O: Remote control sensor
F: FILTER button
K: Time setting buttons
G: CHECK button
M: CL button
A: ON/OFF operation button
E: FAN SPEED selector
button
●
●
●
(T
(T
(T
(T
06-405 Mini-ECOi_TD3 11/6/06 6:18 PM Page 26