Install wiring correctly
(incorrect wiring will dam-
age the equipment).
G Use shielded wires for remote control wiring and
ground the shield on both sides. Otherwise misop-
eration due to electrical noise may occur.
No. 8
No. 3
No. 2
No. 1
I Wiring System Diagram for Group Control
This diagram shows when several units (maximum of
8) are controlled by a remote controller (main unit). In
this case, a remote controller can be connected at
any indoor unit.
Wiring procedure
Wire according to the diagram at right:
G Each successive unit will respond at 1-second
intervals following the order of the group address
when the remote controller is operated.
Group control using 2 remote controllers
It does not matter which of the 2 remote controllers
you set as the main controller.
When using multiple remote controllers (up to 2 can
be used), one serves as the main remote controller
and the other as the sub-remote controller.
No. 8
No. 3
No. 2
No. 1
No. 1
No. 2
No. 8
No. 3
To Next Page
Loading...