21 English
INSTALLING THE BATTERY PACK AND CARD
Install the card
1 Open the battery/card cover.
2 Insert the card.
h Firmly insert the card until it clicks
into place.
3 Close the battery/card cover.
<When removing the card...>
h To remove the card, press it down,
and then release. The card will
protrude slightly, and you can then
pull it out.
CAUTION
Do not attempt to forcibly remove the card.
i Never remove the card when the multi-indicator is flashing red. In doing so,
you risk losing the data stored in the card.
HINT
When not using the camera for a long time, remove the battery pack.
i A small amount of power is still used even if the camera is turned off, and it
is therefore recommended that the battery pack be removed from the
camera if it is not going to be used for a long time. Note that when the
battery pack is removed for a long period, the time and date settings may
be cleared. Before using your camera again, be sure to confirm that the
camera settings are correct.
To Next Page
Loading...
Need help?
General
