Operating Instructions BioPAT
®
Xgas 15
Installation
To assemble the BioPAT
®
Xgas proceed in the
following steps:
t First, place the filters and gaskets on the
are in the filter set for the BioPAT
®
Xgas
(SB-20-02-0001, Spare part kit for BioPAT
®
Xgas). For each recess there are two different
filters. There is a flat filter (fig. 4c: A) and a
thicker filter (fig. 4c: B). The flat filter is hydro-
phobic and the thicker is the particulate filter.
For each recess there is a gasket, a flat filter
and a thicker filter in the filter set (fig. 4c).
t Insert the flat filter into the recesses (fig. 4e).
t Place the gaskets in the recesses (fig. 4f).
Fig. 4c: Filters
A B
Fig. 4d: Filters and gaskets
Fig. 4e: Insert flat filter
Fig. 4f: Place gaskets
To Next Page
Loading...
