Operating Instructions BioPAT
®
Xgas 19
Installation
Connecting the Cables to the Biostat
®
B and
B-DCU II
t Use only the cables that are especially
designed for this purpose. Observe the
specifications below and the “Technical
Documentation on the Bioreactor“.
t Wait until the BioPAT
®
Xgas has reached
room temperature.
Connecting the Y cable
t Take the Y cable of the BioPAT
®
Xgas.
t Connect the female connector with the three
cable outputs to the left plug of the BioPAT
®
Xgas.
t Connect the BioPAT
®
Xgas to the power
supply.
Fig. 5: Cable set included
To Next Page
Loading...
