Sartorius BioPAT Xgas - Page 20

20 Operating Instructions BioPAT
®
Xgas
Installation
Connecting to Biostat
®
B (Serial No. ≤ 1000)
t Connect the analog signal outputs of the
BioPAT
®
Xgas to the analog inputs on the
Control Tower of the Biostat
®
B as follows:
t Take the analog Y signal cable.
t Connect the plug of the Y cable labeled
“Xgas” to the right female connector of the
BioPAT
®
Xgas.
t Connect the plug of the Y cable labeled
“Ext. Sig.-A” to the female connector

®
B.
t Connect the plug of the Y cable labeled
“Ext. Sig.-A” to the female connector

®
B.