Control Commands with Upper-Case Letters or Special Characters
p (print; activate/block auto print)
Restart/self-test
Tare
Internal calibration (adjustment)*
The “P,” “T” and “Z” commands do not affect the menu code settings of the
balance to reinitialize (turns the scale off and back on again). The “S” command
causes the processor to reintialize (turns the scale off and back on again).
The balance will operate according to the commands available up until the
processor is reinitialized. Once the balance has been turned on, the processor will
always recognize the codes entered by the user in the balance operating menu.
Block the keys
Release the keys
Important Note
The p key is not blocked!
Adaptation to Ambient Conditions
Very stable
Stable
Unstable
Very unstable
* = only for balances with a built-in automatic calibration weight
ESC N CR LF
ESC M CR LF
ESC L CR LF
ESC K CR LF
ESC R CR LF
ESC O CR LF
ESC Z CR LF
ESC T CR LF
ESC S CR LF
ESC P CR LF
61
To Next Page
Loading...
Need help?
General