Sartorius FB - Over;Under Checkweighing: Settings and Additional Functions; Parameter Settings, Additional Functions, and Operation Control

50
● Turn on the scale:
Press e/[ON/OFF]
> All display segments light up
briefly
● Select the over/under
checkweighing application in the
Setup menu: Press M
● Select menu:
Press the menu soft key
(w/[TOGGLE])
● Set parameter 2 1 8:
See “Configuring the Scale”
● Exit the Setup menu:
Press M
Setting Parameters for the Over/
Under Checkweighing Application
k Access the Setup menu:
Select Menu
● Set parameters for:
– Automatic initialization when
scale switched on:
3 10 auto-start app.
– Automatic printout when
weight value is within limits
and scale at stability:
4 2 auto print +/-
– Control lines on:
4 3 +/- ctrl ports on
Automatic output of
initialization values to
interface port:
7 1 Print app. param.
– Signal direction for data output
port lines:
8 8 1 input or
8 8 2 output
See “Configuring the Scale”
● Exit the Setup menu:
Press M
Additional Functions
In addition to functions for:
– alphanumeric input
(not during initialization),
– taring
(not during alphanumeric input),
– printing,
you can also access the following
functions from this application:
– calibration
(not during alphanumeric input
or during initialization),
– setup (not during initialization),
– turning off the scale.
Calibration/Adjustment
● Press [ISOTEST]/[TEST]
> See “Calibration/Adjustment”
for further instructions
Setup (setting parameters)
● Press M
> See “Configuring the Scale” for
further instructions
Turning Off the Scale
● Press e/[ON/OFF]
> The scale shuts off
> The display goes blank