Sartorius FB - User Data and Password Management; Entering User Data and Changing Passwords

13
Configuring the Scale
Entering User Data (Input)
Purpose
To display, input or change user
data. You can block access to these
data by assigning a password.
Features
You can display, input or change
the following user data:
– Workstation number* for the
scale: ID (scale ID; max.
20 characters)*
– Weighing series number, to
designate a series or lot:
L ID (lot ID; max. 20 characters)*
– Weight set number for calibration/
adjustment: W ID (weight ID;
max. 14 characters)*
– Exact weight value for calibra-
tion/adjustment of the scale
(see the section on “Calibration/
Adjustment,” starting on page 26
in the chapter entitled “Operating
the Scale; in particular refer
to page 30)
– Password for access to the Setup
menu: Input and Setup:
Menu (max. 8 characters)*
* A decimal point is displayed
together with its preceding digit
or character; it does, however,
count as a separate character.
This also applies when you enter
S ID and NUM as well
as to data entered via the
interface.
** To delete user password:
Enter a decimal point using the
. key and confirm
Factory Settings
Password: No designation
If no password has been assigned,
anyone can access the “Setup:
Input” and “Setup: Menu” functions
without entering a password.
If you assign a password and then
forget what the word is, you can
use the General Password (see
Appendix) to access these menus.
Preparation
Display existing user data:
● Select the Setup program:
Press M
> The soft keys Info, Menu and
Input are displayed in the text
line
● Select the user data input function:
Press the Input softkey
v/[FUNCTION]
> The password prompt is displayed
k If access is blocked by
a password: enter the password
using the alphanumeric input keys
● Display user data:
Press the enter passw.
soft key v/[FUNCTION]
> The last 8 digits of a workstation/
scale number (ID no.), if
any ID is assigned, are displayed
in the measured value line
Enter/Change Password
● Select the Setup menu:
Press M
> The soft keys Info, Menu and
Input are displayed in the text
line
● Select the user data input function:
Press the Input soft key
v/[FUNCTION]
If you have already assigned
a password:
> The password prompt is displayed
k Enter the password
k Press the enter passw.
soft key v/[FUNCTION]
● Write down the password here:
Password = .............................
If you no longer remember the
password assigned:
k Enter the General Password
(see Appendix)
k Press the enter passw.
soft key v/[FUNCTION]
> The last 8 digits of a workstation/
scale number (ID no.), if any ID
is assigned, are displayed in the
measured value line
● Select password setting: Press y
> Password is displayed
in the text line
> If a password exists, it is now
displayed in the measured value
line
● New password: Enter the letters/
numbers for the new password
(8 characters max.)*
The password “none” means that
no password is stored.**
● Confirm input: Press X
● Exit the Setup menu:
Press M
> Restart the application