Sartorius FB - Pin Assignment Chart; Connector Pin Assignments for Interface Ports

69
Pin Assignment Chart:
12-pin round 25-pin RS-232 signal RS-485* signal
connector adapter (SBI and xBPI) (xBPI)
A 18 Control output “heavier” Control output “heavier”
B 2 Data output (RxD) RxD – TxD – N
C 3 Data input (RxD) RxD – TxD – P
D 20 Data Terminal Ready (DTR)
E 7, 8, 14 Signal GND Signal GND
F 13, 25, 12 +5 V output +5 V output
G 16 Control output “lighter” Control output “lighter”
H 5 Clear to Send (CTS)
J 17 Control output “equal” Control output “equal”
K 15 Universal remote- Universal remote-
control switch** control switch**
L 19 Control output “set” Control output “set”
M 11 +12 V output +12 V output
Connect shield to connector housing so that the electrical resistance
is almost zero
* Only with a special data interface – see “Accessories”
** For this function, refer to “Universal Switch for Remote Control”
in the section entitled “Additional Functions”
Pin Assignment Chart
(For devices with 12-pin round
female connector)
Female Interface Connector:
12-contact, with screw lock
hardware for cable gland
Male Connector Required:
Type C091D, 12-pin
Round male connector with screw
lock hardware for cable gland,
Amphenol (IP65) Sartorius order no.:
69QC0010
Operating the Scale