Sartorius LMA200PM - Configuration Menu

Selection: Program name “Ketchup”
(all datasets with the drying program
called “Ketchup”)
Selection: Program name “Ketchup”
plus date and user name
Selection: Short name “Ketchup” plus
selection of individual datasets from
a list of datasets with the “Ketchup”
drying program
In this example, the second line of data-
set 6, with the user name “Paul,” has
been selected for statistical evaluation
and thus is highlighted in green.
Selecting Individual Datasets
§ Configuration under “Setup/Results/
Select:”
Set “by date” to Off
Set “by user” to Off
§ To enable individual selection of data-
sets:
Tap the Indiv. button
§ To select an individual dataset:
Tap the first line of the desired dataset
§ To confirm the selection and highlight
the dataset: Press the
key
* Access rights required
Configuration
The parameters in the “Configuration”
menu are grouped as follows:
– Device
– Results*
– Print parameters*
– Print formats*
Device:
You can enter or modify data affecting
the following areas of LMA200PM
operation:
– Date and time*
– Serial interfaces*
– Built-in printer
– RS-232 interface
– Ethernet*
– Device name
– DHCP
– IP address
– Subnet mask
– Standard gateway
– Remote access for VNC client
– Operating parameters*
– Operating language
– PS/2 keyboard
– Keyclick duration
– Display settings*
– Color scheme
– Brightness
– Weighing module settings*
– Filter adaptation
Results*:
You can set the following parameters
for results:
– Sample ID
– Evaluation of results
Print Parameters*:
You can set the following parameters
for printing:
– Automatic printing
– Headers 1 to 3
Print formats*:
You can set the following parameters
for printing data records and statistics:
– Data record header
– Data record intermediate results
– Data record footer
– Statistics printout
The chapter entitled “Overview of
Parameters in the Setup Menu” shows
a tree diagram of the values that can be
selected or entered for the parameters
described above.
Calibration*
When you select “Cal./adj. weighing
module” and then “External/adjust-
ment” the display shows the following:
For details, see “Calibration and External
Adjustment” in the chapter entitled
“Operation.”
Security management*
The parameters in the “Security man-
agement” menu are grouped as follows:
– Modify user data
– Restore factory settings
– Additional configurations
Modify user data:
You can configure the following:
– Modify user data:
– You can assign group membership,
with the associated user privileges,
and a new PIN to any user except the
administrator that has the user name
“Admin.”
– Delete any user except “Admin”
– Configure new user
You can set up a new user account by
defining name, group and PIN.
– Access rights, supervisor
Select this option to define which of the
following parameters can be edited by
users with supervisor rights:
– SET Calibration
– SET Manage programs
– SET Eval. of results
– SET Print param.
– SET Printout formats
– SET Date and time
– SET Serial interface
– SET Ethernet
– SET Operating parameters
– SET Display settings
– SET Weighing module settings
– User privileges, operator:
Select this option to define which
parameters can be edited by users
with operator rights. The parameters
available for selection are the same
as those listed above for defining
supervisor rights.
14