36
Specifications
Measurement method Sample heated by microwave radiation; moisture content calculated from loss on drying
Microwave generator 1000 W
Power output 2% to 100%, configurable in 1%-steps
Measurement range 8% to 100%
Accuracy From 1 g initial sample weight +/– 0.05%
Response time Approximately 40 to 120 seconds (depends on sample and moisture content)
Display of results % moisture content with calculation options; ppm moisture content,
% volatile components, %, ppm solids, g solids, mg solids, % ratio
Weighing capacity 70 g
Resolution|reading accuracy 0.1 mg
of the weighing system
Reading accuracy of the measurement results 0.001%
Display module 4 VGA
Control elements Touchscreen, 5 function keys
Program memory 320 drying programs with alphanumeric designation
Data storage The 500 most recent results, with statistical evaluation, stored in battery-backed memory
Built-in printer Thermal printer, 40 characters per line
Data interfaces 1 serial RS-232 interface, 1 Ethernet port
Power source 230 V, 50 Hz, 1200 VA (LMA200PM-000EU)
115 V, 60 Hz, 1200 VA (LMA200PM-000US)
Fuse 2 + 10 A/T (5 + 20 mm)
Ambient conditions
Indoor use only
Altitude up to 2000 m
Operating temperature range 5°C to 40°C (41°F to 104°F)
Allowable storage temperature range –10°C to +60°C (14°F to 140°F)
Humidity Maximum relative humidity: 80% for temperatures up to 31°C,
linear decrease to 50% relative humidity at +40°C
Dimensions (H + W + D) 304 + 510 + 535 mm (12 + 20 + 21 in.)
Weight Approximately 22 kg (48.4 lbs)
Pollution degree 2 Normally only nonconductive pollution or temporary conductivity caused by condensation.
Limitation of emissions In accordance with EN 61326-1 (IEC 61326-1):
Group 1, Class B, suitable for use in domestic establishments and establishments
directly connected to a low-voltage power-supply network that supplies buildings used
for domestic purposes.
Immunity to interference In accordance with EN 61326-1, (IEC-1 ):
Immunity test requirements for equipment intended for use in industrial locations (Table 2)
Electrical safety In accordance with EN 61010-1 (IEC 61010-1)
Accessories/Options
Product Order No.
80 glass fiber pads 6906940
500 disposable pipettes YAT01MA
Printer paper (five 20-m rolls) 69MA30100
Specifications
To Next Page
Loading...
