Sartorius PR 5210/10 - Page 60

Profibus Interface PR 5210 Operating Manual
60 Sartorius
6.3.2.2 Parameter 20: Calibration Start/Stop
Write only
Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
Byte 0
Byte 1
Byte 2
Byte 3 Function
Function
1 StartCal
Test the CAL switch, set CalActiv
2 Factory standard
Calibration data and paramters are reset
to factory delivery status (see chapter
3.2)
3 SaveAndExit
The calibration data and parameters
21...53 are stored in EAROM.
CalActiv is reset
4 UndoAndQuitCal
All changes since start calibration are
not valid.
CalActiv is reset.
5 SetDefaultSpan
To be used to start a calibration:
All calibration data are reset, scale in
status not calibrated
FSD = 3000 kg, stepwidth = 1, span =
1.000000 mV/V, deadload = 0.000000
mV/V.