14
After you have accessed the menu of the balance operating
program, the display will show a continuous numerical se-
quence from 0 to 3 for the "page", in addition to the Status code
letter
"L"
or
"C."
When the first digit of the code you wish to
check or change appears, press the tare control.
The "page" code number now stops in the display, and a series
of numbers for the second digit or "line" will start to cycle. Again,
press the tare control to stop the code number of your choice in
the display. Next, the numbers for the "word" (last digit) will cy-
cle in the display. Repeat the procedure to enter the last digit of
the code.
The
!
-symbol that appears indicates the actual setting.
To change any setting ("C" mode), press the tare control as
soon as the appropriate numeric code appears.
Brief display of BUSY and the
!
-symbol confirms your selec-
tion, followed by return to "zero" for the 2nd digit or "line."
How to return to the weighing mode:
press the tare control each time a 0 appears in the numerical
sequence (word, line, page). lf you have changed a menu code,
your code entry will be stored as soon as the display returns to
the weighing mode.
Lock the balance operating program using the menu access
switch (
"L"
readout) and replace the protective cover.
Auto Zero
This balance has an automatic zero tracking function known as
"Auto Zero" (can be turned off by menu code). Any change off
zero < 3 digits per second within the zero tracking range will be
set to zero automatically.
To Next Page
Loading...
