Sartorius Tacta - 3 Tagging the Pipette; 4 Stands and Holders; Installing the Pipette Holder

5
3. Tagging the Pipette
You can use personalized tags to make each Tacta® pipette easily identifiable.
NOTE: If you intend to autoclave the pipette, make sure you use suitably resistant ink.
1. Write the identifying information on the tag.
2. Attach the tag to the finger support.
4. Stands and Holders
For convenience and safety, always keep the pipette upright in its holder or stand when not in use.
4.1 Installing the Pipette Holder
1. Clean the shelf surface with ethanol.
2. Remove the protective paper from the adhesive tape.
3. Install the holder by pressing it against the edge of the shelf.
4. Hook the finger support onto the holder.