Setting the heating program schedule
When the thermostat is turned on and in the advanced thermostat settings you've selected your desired
program mode (4 or 6 daily programs), hold the button for around 5 seconds – now you've entered
the heating schedule editing mode.
On top of the display you'll see blinking days or days. If you wish to select the days or day for which you'll
want to set the heating schedule, move through the setting with the help of the and buttons. So,
for what day is blinking on top and afterwards selected – for that day you'll be setting the heating
schedule. When you've selected the desired day or days, proceed to the next setting by short pressing
the button.
On the left of the screen you have always shown for what heating program you're currently editing the
program (sun, house, …).
Pairing / Connecting the thermostat to the receiver
Setting the receiver in to connecting / pairing mode.
Turn off the receiver - short press the button on the receiver. The receiver is turned of
when the red indicator is not lit! Now hold the button for around 3 seconds so that the
yellow indicator is lit (see image bellow). Release the button.
Receiver is now in the pairing mode and ready to connect with the thermostat.
Now you have blinking time on the right side of the screen. With the help of the and buttons you
change when this program will start – set the start time. After you've set the time, press button to
proceed to the next setting.
Now you're setting the desired set temperature at the set time. With the help of the and buttons you
change the set temperature. When you've set the desired set temperature, again, short press on the
button and now you've finished editing the first heating schedule program of the desired day or days.
You can see on the left side that the symbol of the sun changed to the next symbol, e.g. program.
Proceed this way to set your heating schedule for all the days.
Changes that you’ve made are automatically saved or you can save it manually by short pressing on the
button and now you’ve successfully saved your heating program schedule.
24
! By default, the devices are already
paired. If it happens that the
connection is lost or some other
problem occur, follow the steps above.
When the yellow LED
indicator is lit, the receiver is
in the pairing mode.
25
To Next Page
Loading...
Need help?
General
