Unit 4: Standard Command Codes
E/Pro Programming Reference
4-126 PN: 9001096E
IP ADDRESS SETUP
FUNCTION
Specifies IP address setup method.
FORMAT
<ESC>WIa
a = IP Address setup
0: Manual setup
1: DHCP
Place this command between <ESC>A start code and <ESC>Z stop code.
EXAMPLE
<ESC>A
<ESC>WI1
<ESC>Z
OUTPUT
This command does not result in printer output.
Setting can be printed on the factory test print.
NOTES
You cannot use this command in combination with other commands.
The set parameter will become valid after rebooting.
Default setting of IP Address is as follows:
IP Address setup: 1 (DHCP)
To Next Page
Loading...
