Operation Manual 6. Cleaning and Maintenance
CL608e/612e 43
Cleaning the Print Head using the Lapping Film (SEG No. 1938)
Step 1 Cut the lapping film with a pair of scissors or a sharp
knife to 180mm width.
Step 2 Switch OFF the power to the printer.
Step 3 Place the lapping film between print head and platen
with the abrasive side face-up. Close the print head
with the head latch.
Step 4 Pull the cleaning film by hand slowly toward the front
of the printer.
Step 5 Repeat steps 3 and 4 two or three times.
Step 6 Finally, clean the print head with a print head cleaner
as described previously.
Lapping Film
Print Head
To Next Page
Loading...
