44 CL608e/612e
6. Cleaning and Maintenance Operation Manual
Cleaning the Platen
Step 1 Switch OFF the power to the printer.
Step 2 Open the label access door.
Step 3 Open the print head assembly by pushing the head
latch toward the rear of the printer. The print head
assembly is spring-loaded and will automatically
open as soon as the head latch is disengaged.
Step 4 Apply any SATO approved thermal printer cleaner to
a clean wipe.
Step 5 The platen is the rubber roller directly below the print
head. It should be cleaned of any ribbon or label res-
idue.
Step 6 Repeat as necessary. The platen should be cleaned
whenever foreign matter such as dust or adhesive is
present.
Platen
Head Latch
To Next Page
Loading...
