Section 2. Installation Operation Manual
Page 2-4 SATO M-84PRO
5. If using roll labels (or tags), load the roll onto
the Label Supply Spindle so that the printing
side of the labels faces upwards as it unwinds
from the roll. The labels should be wound
face-in. Push the roll all the way to the inside
of the printer and push the Label Roll Retainer
snugly against the outside of the label roll.
6. If using fanfold labels (or tags) set them on a
flat surface behind the printer. Pass the labels
(printing side up) through the slot in the rear of
the printer.
7. Make sure the labels are routed under the
Label Guide and through the Sensor
Assembly.
8. Open the Label Hold-Down by squeezing the
green tab and the release tab together. The
Label Hold Down is spring loaded and will
open automatically when the latch is
disengaged. Feed the labels under the Label
Guide, under the Label Hold Down, through
the Sensor Assembly and out the front of the
printer.
9. Inspect the label routing and verify that the
path matches that illustrated in the Label
Loading diagram. Set the Adjustable Label
Guide to keep the labels against the inside of
the printer.
10. Close the Label Hold-Down by pushing
downward on the green tab until it latches closed.
NOTE: If the Label Dispenser option has been
purchased, see Appendix A, for proper
label routing instructions.
Label Roll
Label Roll Retainer
Print
Head
Label
Guid
To Next Page
Loading...
