Operation Manual Section 2. Installation
SATO M-84PRO Page 2-3
LOADING LABELS AND TAGS
1. Open the Top Access Door by swinging it up
and to the left. Open the Side Access Door by
swinging it to the rear of the printer.
2. Open the Print Head Assembly by pushing the
Head Latch toward the rear of the printer. The
Print Head Assembly is spring-loaded and will
automatically open as soon as the Head Latch
is disengaged.
3. Loosen the Label Edge Guide and push it to
the outside of the printer to give the maximum
label width.
4. Remove the Label Roll Retainer
Top Access Door
Side Access
Door
Label Roll Retainer
Head Latch
Print Head
Sensor Assembly
Label Hold Down
Label Edge Guide
Label
Guide
To Next Page
Loading...
