SATO M-84PRO - Page 28

Operation Manual Section 3. Configuration
SATO M-84PRO Page 3-5
Label Sensor Selection (DSW3-3). Enables or disables the Label Sensor. If the
Sensor is enabled, it will detect the edge of the label and position it automatically. If it
is disabled, the positioning must be under software control using Line Feed
commands.
Back-Feed Selection (DSW3-4). When Back-Feed is enabled, the printer will
position the last printed label for dispensing and retract it before printing the next
label. The amount of backfeed offset is adjustable.
External Signal Interface. See Section 6: Interface Specifications for information
on the External Signals.
EXT Print Start Signal Selection (DSW3-5). Allows an external device to initiate a
label print for synchronization with the applicator. When DSW3-5 is On, the unit is in
the Continuous print mode, Backfeed is disabled and External Signals are ignored.
DSW3-3 SETTING
Off Not Used
On Sensor Used
DSW3
ON
OFF
12345678
DSW3-4 SETTING
Off Disabled
On Enabled
DSW3
ON
OFF
12345678
DSW3-5 SETTING
Off Enabled
On D i sabled
DSW3
ON
OFF
12345678