SATO M-84PRO - Page 35

Section 3. Configuration Operation Manual
Page 3-12 SATO M-84PRO
CANCEL PRINT JOB
YES NO
If the printer has a print job(s) in memory, selecting YES will
cause the job(s) to be cleared. The default selection is NO. Be
sure you want to cancel the print job(s) before selecting yes as
the job(s) cannot be recovered and will have to be retransmitted
to the printer.
1. Use the Cursor keys to step the cursor to either the YES or
NO selection.
2. Once the correct setting is selected, pressing the ENTER
key will accept the setting.
CANCEL PRINT JOB
COMPLETED
3. After the print job(s) have been cleared from memory, the
printer will beep 3 times and display a COMPLETED
message for 3 seconds and then return to the initial
ONLINE Normal Mode.
4. If you wish to change any of the settings, you must enter
the User Settings mode again by taking the printer
OFFLINE and pressing the LINE and FEED keys.