SATO M-84PRO - Page 41

Section 5. Troubleshooting Operation Manual
Page 5-4 SATO M-84PRO
Error On Sensor Error 3 Short Sensor 1. Paper jam ☺
2. Sensor DSW setting #
3. Sensor level adjustment #
Error Blinks Card R/W Error 1 Long Memory Card
Read/Write
1. Card not formatted #
1. No card recognized #
Error Blinks Card Low
Battery
1 Long Memory Card
Battery Low
1. Card battery needs replacement#
Error Blinks Card No Battery 1 Long No Battery in
Card
1. Card needs battery installed #
Error Blinks Head Open 3 Short Head Open 1. Head not latched ☺
2. Head latch switch bad #
Error Blinks Cutter Error 3 Short Cutter 1. Cutter jam #
2. Cutter sensor dirty #
Error On
Line Blinks
Parity Error 3 Short RS232 Parity
Error
1. RS232 parameter mismatch #
Error On
Line Blinks
Overrun Error 3 Short RS232 Overrun
Error
1. RS232 parameter mismatch #
Error On
Line Blinks
Framing Error 3 Short RS232 Framing
Error
1. RS232 parameter mismatch #
Error On
Line Blinks
Buffer Over 3 Short Buffer Overflow 1. Command stream exceeds buffer
size #
Error Blinks Paper End 3 Short Media End 1. No paper ☺
2. Paper incorrectly loaded ☺
Error Blinks Ribbon End 3 Short Ribbon End 1. Needs new ribbon roll ☺
2. Ribbon sensor needs adustment#
Download Error
R/W Error
Mem Full Error
3 Short Download Error 1. Read/Write error #
2. Corrupted download file #
3. Download file too large #
CopyCard/
Format
R/W Error
No Card Error
Mem Full Error
3 Short Card Copy or
Format Error
1. R/W error during copying. #
2. Card not installed properly. #
3. File too large. #
LED LCD
MESSAGE
AUDIBLE
BEEP
ERROR
CONDITION
POSSIBLE CAUSES