Unit 3: Installation
S8400 Series Operator Manual
3-2 PN: 9001160 (C)
INSTALLATION
UNPACKING
When unpacking the printer, take note of the following:
1. The box should stay right-side up. Lift the printer out of the box carefully.
2. Remove all of the packaging from the printer.
3. Remove the accessory items from the packaging.
4. Set the printer on a solid, flat surface. Inspect the shipping container and printer for any sign of damage that
may have occurred during shipping. Please note that SATO shall hold no liability for any damage of any kind
sustained during shipping of the product.
5. Ensure all components are present.
6. Report any damaged property to the shipping carrier.
Notes:
• If the printer has been stored in the cold, allow it to reach room temperature before turning it on.
• Please do not discard the original packaging box and cushioning material after installing the printer. They may
be needed in the future, if the printer needs to be shipped for repairs.
Figure 3-1, Accessories
Included Accessories
After unpacking the printer, verify that you have the materials that are shown in Figure 3-1.
User documents
(Quick Guide,
Warranty, etc.)
AC power cord*
*The shape of the plug on the power cord
may vary, depending on the location in
which it was purchased.
To Next Page
Loading...
