3 Printer operation Self test
24
Printing speed unit is inch per second (ips).
17. ABS. Darkness
Display the current darkness. You can use the SZPL command ~SD to define
it.
18. Trim. Darkness
Display the adjustment of the current darkness. You can use the SZPL
command ^MD to define it.
19. Print Method
It is either thermal transfer (TT) or direct thermal (DT) printing. TT requires
ribbons and DT doesn't.
20. Print Length
Display total print length.
21. Cut Count
It counts the times the cutter cuts.
22. Caret Control Char
The control character your printer is using.
23. Delimiter Control Char
The control character your printer is using.
24. Tilde Control Char
The control character your printer is using.
25. Code page
The character set table.
26. Media
The media type in use.
27. Calibration mode
Intelli Mode: Just install labels, latch print module, press FEED button once,
and then the printer will feed 1-2 labels to detect next gap / black mark
before printing. The printer will feed 1-2 labels automatically before printing,
if FEED button is not pressed.
28. Reprint After Error
When it is enabled, your printer reprints the label after the error fixed if it is
printed incorrectly due to the error.
29. Backfeed Enabled/Disabled
To Next Page
Loading...
