SATO WS208 - 6 Specifications; 6.1 Printer

6 Specifications Printer
40
6 Specifications
This chapter provides specifications for the printer. Specifications are subject
to change without notice.
6.1 Printer
Model
WS208
WS212
Print method
Direct Thermal
Resolution
203 dpi (8 dots/mm)
300 dpi (12 dots/mm)
Media Alignment
Centered
Operation Mode
Standard: Continuous mode, Tear-off mode
Optional: Cutter mode, Peeler mode
Sensor
Reflective Sensor (Movable)
Media Transmissive sensor x 1 (fixed, 6.27mm offset)
Head Open Switch
Operation interface
LED indicator x 2, Button x 1
Print Speed
2, 3, 4, 5, 6, 7 inches/sec
(50.8, 76.2, 101.6, 127, 152.4,
177.8 mm/sec)
2 &3ips for peel off mode
2, 3, 4, 5 inches/sec
(50.8, 76.2, 101.6, 127
mm/sec)
2 &3ips for peel off mode
Printable Area
Max. length 100”(2540mm)
Max. length
50”(1270mm)
Print Ratio
Average print ratio within 15 % or less (whole print layout
area)
Full width with 1mm pitch is required
Interface
USB hosts(Type A), USB device(Type B) , Ethernet
Programming
Language
SDPL+SEPL+SZPL
Accessories
Peeler, Full Cutter
On-Board Memory
Standard Memory (Flash ROM): 16 MB
User Memory: 8 MB
Standard Memory (SDRAM): 32 MB
USB storage up to 32 GB (FAT32 format only)