1 Introduction Printer Lights
12
1.4.2 System Mode
The system mode consists of status light color combinations. It contains a
list of commands for you to select and run.
To enter the system mode and run the command, do the following:
1. Turn off the printer.
2. Press and hold the FEED button and turn on the printer.
3. Both status lights illuminate solid orange for a few seconds. Next, they
turn to green shortly and then turn to other colors.
4. When status lights show the color combination you need, release the
FEED button immediately.
5. Press the FEED button to run the command.
The following table is the command list of the system mode.
To Next Page
Loading...
