SATO WS4 Series - Specifications; Printer

7 Specifications Printer
78
7 Specifications
This chapter provides specifications for the printer. Specifications are subject
to change without notice.
7.1 Printer
Model
WS408DT
WS412DT
WS408TT
WS412TT
Print Method Direct Thermal Direct Thermal or Thermal Transfer
Resolution
203 dpi
(8 dots/mm)
300 dpi
(12 dots/mm)
203 dpi
(8 dots/mm)
300 dpi
(12 dots/mm)
Media
Alignment
Center Alignment
Operation
Mode
Standard: Continuous, Tear Off
Optional: Full Cutter, Dispenser
Sensor
Gap Sensor (Transmissive, Fixed) - Factory Default Sensor
I-Mark Sensor
Head Open Switch
Ribbon Sensor
Print Speed
2, 3, 4, 5, 6
inches/sec
2, 3, 4
inches/sec
2, 3, 4, 5, 6
inches/sec
2, 3, 4 inches/sec
(50.8, 76.2,
101.6, 127,
152.4 mm/sec)
(50.8, 76.2,
101.6 mm/sec)
(50.8, 76.2, 101.6,
127, 152.4
mm/sec)
(50.8, 76.2, 101.6
mm/sec)
2 &3 ips for dispenser mode 2 &3 ips for dispenser mode
Print
Darkness
Darkness level – SBPL: 1~5
Default: SBPL 3 Default: SBPL 2
Max
Printable
Area
Length 999 mm (39.33") x Width 104 mm (4.01")