SATO WS412DT - 6 Lan; Basic Specifications

30
6 LAN
6.1 Basic Specifications
Interface board
(Onboard LAN)
Connectors
Cable type 10BASE-T, 100BASE-TX
Cable length 100m and under
Link/Status LED
Lighting up when establishing the link to Ethernet device by auto negotiation.
LED
Color
Description
LINK
Green
Lighting when establishing the link
SPEED
Orange
Lighting when recognizing the connection to 10BASE-T
Lighting when recognizing the connection to 100BASE-TX
COLLISION
Red
Lighting when collision occurs
Maintenance function
Print of LAN settings
Printing out the LAN settings on a label in user test print and factory test print.
Initialization of LAN setting
Initializing the LAN settings by [All Clear] in factory clear mode.
(Refer to the Operation Specifications for more details.)
Communication condition
setting
The following settings can be set by the commands.
Item
Command
Setting range
LAN mode
<I3>
Protocol for driver (STATUS4) cyclic
response mode *1
Protocol for driver (STATUS4) ENQ
response mode *1
STATUS3 *2
IP address
<W1>
0.0.0.0 ~ 255.255.255.255
Subnet mask
<W2>
0.0.0.0 ~ 255.255.255.255
Gateway address
<W3>
0.0.0.0 ~ 255.255.255.255
IP address
setting
<WI>
Manual setting
Use of DHCP
* 2-port connection (Port1024 and Port1025) or 1 port connection (Port9100)
is available.
* 1 port connection (Port1024 or 9100).