Saturn 2003 Ion User Manual

Important: With the AIR BAG fuse removed and the
ignition switch in the ON position, the AIR BAG
warning indicator illuminates. This is normal operation,
and does not indicate an SIR system malfunction.
5. Locate and remove the AIR BAG fuse from
the body control module fuse center.
6. Remove the coat hooks.
7. Remove the trim panel from the high mount stop
lamp by pulling at the clip locations.
8. Gently pull back on the headliner to access the
right pretensioner connector.
9. Remove the connector position assurance (CPA)
from the right/passenger pretensioner connector.
10. Disconnect the right/passenger connector.
11. Remove the garnish molding from the upper
lock pillar.
12. Remove the connector position assurance (CPA)
from the right/passenger roof rail module
connector.
13. Disconnect the right roof rail module yellow
connector from the vehicle harness yellow
connector.
Enabling Procedure
1. Remove the key from the ignition switch.
2. Connect the right roof rail module yellow connector
to the vehicle harness yellow connector.
3. Install the CPA to the right roof rail module
connector.
4. Install the garnish molding to the upper lock pillar.
5. Gently pull back on the headliner to access the
right pretensioner.
6. Connect the right pretensioner connector and
install the connector position assurance (CPA).
899819
899820
899820
3-174 2003 Saturn Ion

Saturn 2003 Ion Specifications

General

Brand	Saturn
Model	2003 Ion
Category	Automobile
Language	English