Hinge Pillar Body Sectioning - Front
Removal Procedure
Caution: To avoid personal injury when exposed
to welding flashes or to galvanized (Zinc Oxide)
metal toxic fumes while grinding/cutting on
any type of metal or sheet molded compound, you
must work in a properly ventilated area, wearing
an approved respirator, eye protection, earplugs,
welding gloves, and protective clothing.
Caution: Sectioning should be performed only in
the recommended areas. Failure to do so may
compromise the structural integrity of the vehicle
and cause personal injury if the vehicle is in a
collision.
The sedan body side outer panel is available either in
one piece or in front or rear portions. The front and
the rear halves are cut about half way across the rear
door opening. You can perform any one of these
replacement procedures separately or in any
combination, depending upon the extent of damage to
the vehicle. Sectioning must take place in specified
areas only. Stay away from the door and window
opening radius areas. Section only in straight areas of
the openings.
The coupe body side outer panel is available as a
one-piece panel only. You can perform any one of
these replacement procedures separately or in
any combination, depending upon the extent of the
damage to the vehicle. Sectioning must take place in
specified areas only. Stay away from the door and
window opening radius areas. Section only in straight
areas of the openings.
874221
874304
3-78 2003 Saturn Ion
To Next Page
Loading...
Need help?
General
