Savant IP Video with Audio Processing Deployment Guide
Copyright © 2018 Savant System, LLC
Appendix A: 10G Network Requirements
The following list is the settings that need to be configured on any Switch that is being used for the Audio/Video over IP system.
IMPORTANT!
Not all of these settings are on all network switches.
– 10G Managed Switch with SFP+ ports
– IGMP Snooping Enabled.
– Enable IGMP Snooping on all ports for the VLAN in use.
– IGMP Querier Enabled.
– Enable IGMP Querier on all ports for the VLAN in use.
– Filter/Drop Unregistered Multicast Traffic Enabled.
– Unregistered Multicast Flooding Disabled.
– FASTLEAVE enabled (Optional*).
– Enable FASTLEAVE on all ports for the VLAN in use (Optional*).
* FASTLEAVE will make changing services faster.
Switch considerations
One SFP+ port is needed for each source. And one 10G port is needed for each endpoint. The type of port needed depends on the cable length to the Video
Output IP Receiver. If the cable length is more than 300ft (100m) it will require the use of a PAV-VOMVPF1 using a SFP+ port on the switch.
To Next Page
Loading...
